Embroidered Floral Fabric Pendant Light

A closer fit for your
everyday comfort.

Embroidered Floral Fabric Pendant Light — Rose Embroidery with Pearl Trim, 3 Sizes A pleated fabric dome shade — available in Dia 40, 50, or 60 cm — hangs from a dark wood-finish rod and canopy. The off-white fabric ground carries hand-embroidered pink roses and green leaves placed across the panels, with a row of small pearl beads stitched along the scalloped lower hem. The single E27 socket inside the dome casts diffused downward light through the fabric, producing a warm, even glow across a bedroom nightstand, dining table, or kitchen breakfast nook. The pleated construction holds the shade's bell profile without an inner wire cage visible from below. Key Features Rose Embroidery on Fabric Pink rose and green leaf motifs embroidered directly onto the off-white fabric panels — not printed or applied. Pearl Bead Hem Trim A continuous row of small pearl beads lines the scalloped lower edge, visible from below when the light is on. 3 Sizes Available Dia 40 cm (15.7"), 50 cm (19.7"), or 60 cm (23.6") — same design scaled for different table and room sizes. Dark Wood Rod & Canopy The hanging rod and ceiling canopy use a dark walnut-tone wood finish — no visible metal hardware from below. Pleated Bell Profile Vertical pleats run the full height of the shade, forming a structured dome that holds shape without sagging. E27 Standard Socket Single E27 base — compatible with standard LED bulbs. Bulb not included. About the Embroidered Fabric Shade The embroidery is applied panel by panel before the shade is assembled. Slight variation in the position of rose motifs between individual units is a normal result of hand-embroidery, not a quality defect. The pearl bead trim is hand-stitched along the hem and may show minor spacing irregularities consistent with handwork. Bulb Not Included This pendant uses a single E27 socket. For warm ambient light through the fabric shade, use a 6–10W LED at 2700–3000K. Avoid incandescent or halogen bulbs above 25W — the heat output is too close to the fabric material. Size Options Size Diameter Best For Socket Small Φ40 cm / 15.7" Bedside table, reading nook, hallway E27 × 1 Medium Φ50 cm / 19.7" Dining table (2–4 persons), bedroom center E27 × 1 Large Φ60 cm / 23.6" Dining table (4–6 persons), living room accent E27 × 1 Shape Diagrams Click any diagram to enlarge the dimensions for each size. Small Φ40 cm / 15.7″ Medium Φ50 cm / 19.7″ Large Φ60 cm / 23.6″ 🔍 Click any thumbnail to open full size in a new tab Specifications Product Type Pendant Light Available Diameters Φ40 cm (15.7") · Φ50 cm (19.7") · Φ60 cm (23.6") Shade Material Woven fabric with hand embroidery Embroidery Pink rose and green leaf motifs Trim Pearl bead row along scalloped lower hem Rod / Canopy Dark wood-finish (walnut tone) Socket E27 × 1 Max Wattage 40W Bulb Not included Wiring Hardwired Voltage AC 110–240V Color Off-white with pink/green embroidery (as shown) Certification Compatible with North America, Europe, Australia, Saudi Arabia Use Dry indoor locations only Installation Notes Hardwired ceiling installation — a licensed electrician is recommended. Compatible with a standard wall switch (not included). This pendant is not rated for Triac dimmer switches. E27 socket — insert bulb and twist clockwise to lock. Bulb not included. Hanging cord length is adjustable at the ceiling canopy before final installation. For indoor dry locations only. Not suitable for bathrooms, covered porches, or laundry rooms. Downloads & Resources Spec Sheet FAQ Which size works over a standard dining table? For a 4-person dining table (around 36–42" wide), the Φ50 cm (19.7") shade is a good match — the shade diameter stays within the table edge visually. For a 6-person table (48" or wider), the Φ60 cm (23.6") gives better coverage. The Φ40 cm works best as a single pendant over a small breakfast table or as a bedside pendant. Hang the bottom of the shade at 28–32" (70–80 cm) above the tabletop for even ambient light across the surface. Will the pearl beads and embroidery hold up over time? The embroidery thread is sewn through the fabric base and does not peel or flake. The pearl bead trim is hand-stitched with thread along the hem — avoid pulling on individual beads during installation or cleaning. For dusting, use a soft-bristle brush or low-pressure compressed air; do not wipe with a damp cloth, as moisture can loosen the embroidery backing or cause the fabric to spot. What style of room does this pendant suit? The combination of embroidered florals, pearl trim, and a dark wood rod reads well in cottagecore, farmhouse, and vintage-inspired bedrooms and dining rooms. It also works in transitional spaces where one decorative fabric element is introduced against neutral walls and furniture. It is not a fit for industrial, minimalist, or Scandinavian interiors. Can I use this pendant in a bedroom as the primary light source? Yes, in a standard bedroom (10–12 ft / 3–3.6 m square). Use the Φ50 or Φ60 cm size with a 10W warm white LED (E27, 2700–3000K, 800+ lumens) for general ambient light. For task lighting at a desk or vanity, supplement with a separate table lamp — a single pendant over the room center does not direct light to specific work areas. Is this pendant certified for use in the United States? Yes. It holds certifications compatible with North America, Saudi Arabia, Europe, and Australia, and operates on AC 110–240V worldwide. Sizing & questions Every piece is made to order in our own atelier — here is what most clients ask before choosing theirs. What bulb do I need, and is it included?+Uses one E27 socket. Bulb not included. Use a 6–10W LED at 2700–3000K for warm light through the fabric. Avoid incandescent or halogen above 25W due to heat risk near the fabric. Can I customize the embroidery or fabric color?+This design comes in beige with hand-embroidered pink roses and green leaves. Custom sizing and finishes are available in our workshop—contact us about made-to-order variations. How is the embroidery and pearl trim made?+Pink rose and green leaf motifs are hand-embroidered panel-by-panel before assembly; slight placement variation is natural. Pearl beads are hand-stitched along the scalloped hem with minor spacing irregularities from handwork. Do I need an electrician to install it?+Hardwired ceiling installation is recommended with a licensed electrician. Works with a standard wall switch (not included). Hanging cord length adjusts at the canopy before final wiring.